Loft Access Hatch - 1 Hour Fire Rated



Loft Access Hatch


Metal Faced Insulated Loft Hatch Ceiling Access Panel, 1 Hour fire rated, Metal Door, 25mm wide Picture Frame, 3 Point Locking System, Single Door Unit, Powder Coated RAL 9010 30% Gloss, the 1st dimension stated is the hinge side.This panel has a Fire Test Certificate up to 575x740mm in a Ceiling application covered by Fire Certificate Number 221643 Anything above these sizes will be manufactured to the same construction as tested.

Minimum Size - 0300 x 0450mm

Maximum Size - 1000x1000mm

Make sure the structural opening is at least 7mm larger than the panel size, back of frame size. E.G a 600x600mm panel size requires a 607x607mm hole size. Remove the door from the frame and place the frame into the set hole. Fix through the appropriate fixing holes within the frame ensuring the frame is pushed up against the structural opening surround. Check the frame is square by measuring corner to corner. Refit door and lock in place; the door and frame should be flush. Independent bracing or support may be required to take the weight of the Loft Hatch. Apply Intumescent acrylic mastic on both faces of the frame, nominally 5mm wide sealing to the supporting construction. THIS PRODUCT MUST BE INSTALLED INTO A VENTED ROOF SPACE

3 Way Lock
Lockable Chrome Handle
5MB 5mm Bit
ATL KeyRetaining Lock
Lockable Pull Latch
EP 3 Point Euro Lock

FlipFix, the fastest way to install an Access Panel

With our unique Fitting Device, Mitreless Frame and new Flush Lock system. FlipFix Access Panels are 5 times quicker to fit compared to a traditional panel saving you 80% on fitting costs. No screws or glue required and no need for bracing or supports just cut, fit and flip!

Now With The New Flush Lock
Available In 1 & 2 Hour Fire Rating
Fastest Panel Installation