Rapid Fit Plasterboard Riser Door - Non Fire Rated



Our unique Rapid Fit hinge system has revolutionised the riser door Access Panel by reducing door fitting times on site by as much as 30 minutes. Say goodbye to old Piano Hinge technology and say hello to future of riser doors Access Panels!

Plasterboard Faced Wall Access Panel, Supplied with the Rapid Fit Hinge System, Non fire rated, Plasterboard Door, Beaded Frame, 3 Point Locking System, Single Door Unit, Powder Coated RAL 9010 30% Gloss, the 1st dimension stated is the hinge side.


Minimum Size - 0300 x 0300mm

Maximum Size Single Door - 2800x0900mm

Maximum Size Double Door - 2400x1800mm

Make sure the structural opening is at least 7mm larger than the back of frame size. E.G a 600x600mm panel size requires a 607x607mm hole size. Remove the door from the frame and place the frame into the set hole. Fix through the appropriate fixing holes within the frame ensuring the frame is pushed up against the structural opening surround. Check the frame is square by measuring corner to corner. Refit door and lock in place; the door and frame should be flush. Independent bracing or support may be required to take the weight of the Access Panel. (Please note that it is important that prior to applying the plaster skim coat, a joint filler and a scrim tape is applied over the junction between the beaded frame and the plasterboard in order to prevent cracking of the skim coat)

3 Way Lock
Lockable Chrome Handle
5MB 5mm Bit
ATL KeyRetaining Lock
TC Touch Catch
EP 3 Point Euro Lock
Chrome Handle

FlipFix, the fastest way to install an Access Panel

With our unique Fitting Device, Mitreless Frame and new Flush Lock system. FlipFix Access Panels are 5 times quicker to fit compared to a traditional panel saving you 80% on fitting costs. No screws or glue required and no need for bracing or supports just cut, fit and flip!

Now With The New Flush Lock
Available In 1 & 2 Hour Fire Rating
Fastest Panel Installation